Flanged Tap In
Nordfab
$95.38
(No reviews yet)
Write a Review
Nordfab
Flanged Tap In
Tap-In to cut into existing lines and connect to a Flanged Application at a right angle.
Nordfab Flanged Tap In duct fittings are used to cut into existing lines of industrial ducting to begin a flanged section. They utilize a 90° angle to transfer the air flow. Saddle length and width is 3" in all directions from Branch Tube C.
Rotational Angle Flanges retained vanstone lip is standard. Available with QF ends in diameters up to 24" and other end types, sizes, materials and gauges upon request.
Product Features
- 3" - 24" diameters
- 90° angle
- Cuts into duct lines
- For flanged end applications
- Angle Flanges have Van Stone lips
Product Specifications
| Diameter | 3 - 24 inch |
| Gauge | ≤12":22ga, ≥13":20ga |
| Material | Galv, 304SS |
| Duct Type | Flange |
| Edge | Vanstone Lips |
Info & Guides
- Technical Data Sheet, Nordfab Tap In
- Temperature Guide, Nordfab Ductwork
- General Specifications, Nordfab Ductwork
Questions & Answers
How do I connect to the end of an existing non QF system?
We offer a full line of adapters to connect to any existing pipe you might have.
When do I need to use stainless steel?
Stainless steel is used in FDA, chemical and high temperature applications.
Still have questions?
Browse our frequently asked questions page or contact us.
|
